Home Theater Forum and Systems banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I want to use the pre amp outputs of a Denon AVR 3312 for zone 2 to hook up to a Samson servo 550 amp.

The Samson servo 550 specifies the input requirements as " >10K ohm balanced / 10kohm unbalanced" 4 dBu.

Are the Denon zone 2 pre amp outputs compatible with the Samson?


Then I want to output the 4 ohm X 275 w outputs of the Samson to a Russound SDB-4 splitter to drive 3 pairs of speakers (all 3 pair are 8 ohm).


I tried to connect this all and was not getting much sound out.

Is there a compatibility issue?:dontknow:
 
1 - 2 of 2 Posts
Top