[brucek]

I did the calibration to 75db first but when I did a sweep the volume was so loud well about the 75db set during calibration.

You likely calibrated with a pink noise that didn't represent the end frequency limits of the measurement sweep. That's why the double check "Check Levels" button is available on the measurement panel. The "Check Levels" button on the measurement panel uses the end limits as its cut frequencies rather than the conventional pink noise.

brucek

 

[brucek]

Them I go to do a measurement the volume in much louder then when I calibrate it or do a check level.

Shouldn't be, if the limits of the sweep match the pink noise limits you used to do the Check Levels.

brucek