Home Theater Forum and Systems banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi all, have a question for you all. I have the above receiver, sub is a CSS SDX-15 powered by a Dayton Audio SA1000 amp.
Amp is connected to pre out for sub.
I ran the YPAO setup, it finds the sub, and I hear it during the setup.
Problem is, there is no output from the sub otherwise. I have made sure it is selected im my set up, even bumped the output in level settings.
Also, when i run the test tone in manual setup, no sound from the sub
Any ideas?
 
1 - 1 of 1 Posts
Top