Good afternoon!
After reading some of the posts in the DIY-Subwoofer forum I'm after a recommendation to connect my receiver to my amp. Should I...
Use an RCA to 1/4" Mono cable and run with it.
-or-
Use an RCA to XLR cable and run with it.
-or-
Use an RCA to XLR cable and go to a Samson S-Convert bumpbox, then XLR to the amp.
-or-
Something else?
The reason I ask is, the post I read explained how there's a signal difference when simply connecting the receiver to the amp without a bump box. The bump box increases the line level to what the amp is expecting. Does this make any sense? Thanks for your thoughts.
-HD
After reading some of the posts in the DIY-Subwoofer forum I'm after a recommendation to connect my receiver to my amp. Should I...
Use an RCA to 1/4" Mono cable and run with it.
-or-
Use an RCA to XLR cable and run with it.
-or-
Use an RCA to XLR cable and go to a Samson S-Convert bumpbox, then XLR to the amp.
-or-
Something else?
The reason I ask is, the post I read explained how there's a signal difference when simply connecting the receiver to the amp without a bump box. The bump box increases the line level to what the amp is expecting. Does this make any sense? Thanks for your thoughts.
-HD
