Thanks! Those are great.

Now, if I can figure out how to print them one a 1:1 scale, these could be used to help with the drilling of the mounting holes, and also for testing to make sure bracing doesn't interfere with the driver.

 

Ahh. It would have been cool if I had noted the drawing scale.

For the record, the documents are standard 8.5x11 and the drawing scale is 1:4.

I'll think a bit on how you could go about printing to scale. I assume you don't have a wide-format printer.

 

I have figured out a way to print in full scale across multiple pages. I can create PDF with multiple pages that'll print on 8.5x11. However when I do this, it creates it with a full "bleed", ie. the image goes to the very edge of the page, and I don't know how that will work with most printers. Perhaps your print window will alert you that you will cut off part of the image. That would be fine, as long as you line the pages up to one another without any spaces.

Curtis, what size driver are you going to use? I'll post an experimental file for you to try. Tell me the size and whether you want the drawings with or without the gasket. I'd rather start with one for now to see if it works.

 

Awesome idea.
Zach

 

Nick,

Give me a shout before you go forward with this. The magnet depth on both is slightly not-to-scale (by about 1/2 inch).