I think my UCA202 is bad. I am trying to calibrate it with the loopback hooked up. I get an output signal but no input signal. I have tried both channels and have searched this forum for a solution but haven't found a thread that describes my situation. I'm pretty sure I have it hooked up correctly. Anyone have any ideas?
flyng_fool
One way to check the performance of your UCA202 is to download another piece of ( audio recording ) software such as 
since it offers a recordable audio input .
It's cross platform, which is handy for those using the Mac .
Work with it to see if you can get input / if so / you don't have a problem with your UCA202 .
If you can't get input in that setup / then that's 2 strikes against your sound card / time to add a third input scenario ( if that fails ) then it's time to return the 202 ( or junk it ) .
The third piece of free software ( to check for input veracity on a PC ) can be the basic ( free ) version of
<> EarlK
since it offers a recordable audio input .It's cross platform, which is handy for those using the Mac .
Work with it to see if you can get input / if so / you don't have a problem with your UCA202 .
If you can't get input in that setup / then that's 2 strikes against your sound card / time to add a third input scenario ( if that fails ) then it's time to return the 202 ( or junk it ) .
The third piece of free software ( to check for input veracity on a PC ) can be the basic ( free ) version of
<> EarlK
There might be some setting with your OS sound mixer that need attention. John’s usually good at telling where to look for those.
Regards,
Wayne
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
